A8 Quattro Sedan V8-4.2L (ABZ) (1998)
![background image](/audi/a8_quattro_sedan/v8-4.2l_(abz)/Page-680002.png)
-
Connect multimeter US1119 (Fluke 83 or equivalent) and measure resistance across sensor terminals 1 and 2, using adapter cables from VAG1594
connector test kit.
Specified resistance value (vs. temperature)
If resistance is outside specified range:
-
Replace ECT sensor.
-
Check readiness code. If DTC memory has been erased, generate new readiness code.
Refer to "Monitors, Trips and/or Drive Cycle (Readiness Code)/Checking, Readiness Code" See: Powertrain Management/Computers and Control
Systems/Testing and Inspection
Refer to "Monitors, Trips and/or Drive Cycle (Readiness Code)/Generating, Readiness Code" See: Powertrain Management/Computers and Control
Systems/Testing and Inspection
If resistance is OK:
-
Connect VAG1598/19 test box to ECM harness connector. Refer to "Scan Tool Testing/Scan Tool Connecting and Initial Checks/VAG1598/19
Test Box, Connecting" See: Powertrain Management/Computers and Control Systems/Testing and Inspection
-
Disconnect ECT sensor harness connector.