A8 Quattro Sedan V8-4.2L (AKB) (2002)
^
Install new needle bearing and place sleeve 2080 A on new needle bearing -1-.
Note:
The sleeve must be placed on the center of the sleeve.
^
Using punch VW 408 a, drive needle bearing in to stop until flush with distributor housing.
^
Install snap ring item -16-, to secure needle bearing.
^
Install front gear 2 carefully.
^
Install guide plate and fastening ring and fasten with bolts.
^
Carefully install clamping nut item -14-,.
Note:
Before the distributor gear is installed, the following test steps must be carried out:
^
Check sealing ring for output flange/drive shaft for damage or lack of seal and replace if necessary .
^
Check double sealing ring of front final drive intermediate flange for damage or lack of seal and replace if necessary .
Tightening torques