A8 Quattro Sedan V8-4.2L (AUX) (2001)
^
With wear indicator
4. Brake pad securing spring
5. Retaining pin
6. Circlips
7. Cylinder bolts, 110 Nm
^
Always replace
8. Bracket
^
Bolt to brake caliper housing
^
Insert harness connector for brake pad wear indicator
9. Brake line, 13 Nm
10. Harness connector for wear indicator
^
Insert line for brake pad wear indicator in line retainer
Brake pads, removing and installing
Removing
Note: When removing, mark brake pads that will be used again. Install in the same position, otherwise braking effect will be uneven!
-
Raise vehicle.
-
Remove wheels.
-
Secure brake disk using a wheel bolt.
-
Disconnect connector for brake pad wear indicator
-
Disengage connector from bracket using a screwdriver and simultaneously turn connector 90°
-
Lift connector up and out and disengage wire