A8 Quattro Sedan V8-4.2L (AUX) (2001)
/Page-1026002.png)
4 - Fiber optic cable
^
With wiring harness and LEDs for basic illumination
^
Wire routing go to Figs. 1 , go to 2
5 - Insert
^
Disconnect from cover -3- together with fiber optic cable -4-
6 - Bolt
^
Install together with washer
^
Qty: 4
7 - Shutter
^
Unclip wiring holder on bracket -23-, disconnect connector
^
Wire routing go to Figs. 1, go to 2
^
Remove from guide together with individual transmission range display -8-
8 - Individual
^
transmission range display
^
With lamp holder and wiring harness
^
Unclip from four holding tabs on shutter -7- (slide lamp holder slightly toward center of shutter)
9 - Guide
^
To remove, unlock four holding tabs on bracket -23-
10 - Selector lever
^
Remove together with pull rod -12- and spring -11-
11 - Spring
^
For pull rod
12 - Pull rod
^
Install in selector lever, together with spring -11-
13 - Notched plate
^
To remove, loosen snaps to cable lever go to Fig. 4
14 - Cable lever
^
Grease bearing points for cable lever axles before installing
15 - Engagement
^
for Tiptronic
^
Not applicable to USA/Canada
16 - Bolt
^
For detent
17 - Detent
^
Attach to bracket together with spring clip go to Fig. 4
18 - Bolt
^
For selector lever -10-
^
Removing: press out to back
^
To install, place chamfered surface on head of bolt toward contact surface of bracket
19 - Clip
^
Not applicable to USA/Canada
20 - Toothed ring
^
Always replace
^
2 pieces (left and right)
^
for securing cable lever axles axially
^
Removing: pry out using screwdriver
21 - Cable lever axle, left
^
For mounting cable lever -14-
22 - Cable lever axle, right
^
For mounting cable lever -14-
Note:
-
The left cable lever axle is shorter than the right lever axle.
23 - Mounting bracket
24 - Washer
25 - Bolt
^
Not applicable to USA/Canada
26 - Wiring harness
^
Wire routing go to Figs. 1, - 2
27 - Clip
^
For bolt -18-
28 - Tiptronic switch -F189- (recognition)
^
Not applicable to USA/Canada
29 - Tiptronic
