A8 Quattro Sedan V8-4.2L (BGK) (2006)
Scuff Plate: Service and Repair
Trim
Rear Cross Panel Trim
1 - Rear cross panel trim
‹› Removing
-
Pry out upper part - 4 - or spreader clips - 3 - (Qty. 3) using a flat-head screwdriver.
-
Remove spreader clips - 3 - (Qty. 3).
-
Pull out rear cross panel trim - 1 - upward and unclip clips - 2 - when doing this.
‹› Installing
Installation is reverse of removal. Observe the following when doing so:
‹› Replace damaged clips - 2 - and spreader clips - 3 - as well as upper parts - 4 -.
‹› Side tabs on rear cross panel trim must be located in recesses of the rear cross panel trim.
‹› After assembling trim, make sure seal is properly fitted.
2 - Clips (Qty. 4)
‹› Replace if damaged