A8 Quattro Sedan V8-4.2L (BGK) (2006)
Installing
Installation is carried out in the reverse order, when doing this note the following:
-
Before installing air intake housing, seal housing joint at areas marked - C - and - D - thoroughly with silicone sealant D 176 001 A3.
-
Seal grommet through which wiring harness is routed into air conditioner (to Fresh Air Blower Control Module J126) with silicone sealant D 176
001 A3 (to prevent ingress of water into air conditioner through grommet or past grommet).
-
Install the removed components again in reverse order.
NOTE:
-
If there are complaints about moisture (evaporator on windshield, odor), a sponge rubber strip dia 3 mm - A - should be inserted in addition to
sealing measures described, starting and finishing at area - B -. In the area marked - B -, in which the groove is narrower, there should be no
sponge rubber strip.
-
Use commercially available sponge rubber strip, soft type dia 3 mm.
-
Check DTC memory of Climatronic Control Module J255 and erase DTCs displayed if necessary. Vehicle Diagnosis, Testing and Information
System VAS 5051 in "Guided Fault Finding" function.
-
Perform basic setting and output Diagnostic Test Mode (DTM) on the A/C system. Vehicle Diagnosis, Testing and Information System VAS 5051
in "Guided Fault Finding" function.