A8 Quattro Sedan V8-4.2L (BGK) (2006)
Installation is performed in the reverse order of removal. Observe the following when doing so:
-
Unclip the line from the Servotronic solenoid valve (N119) from the transport retainers.
-
Insert the steering gear from the left and insert the left front bolt in it.
-
Rotate the steering gear to the right until the right bolt can be inserted in it.
-
Position steering gear at plenum chamber (2nd mechanic needed).
‹› Make sure the bolt threads and contact surfaces are free of oil and grease.
-
Install the bolts but do not tighten them yet.
Tightening Sequence
-
Tighten the bolt - A -. Refer to - item 6 - in => [ Power Steering Gear Assembly Overview ] See: Power Steering Gear Assembly Overview.
-
Tighten the bolt - B -. Refer to - item 6 - in => [ Power Steering Gear Assembly Overview ] See: Power Steering Gear Assembly Overview.
-
Finally tighten the bolt - C -. Refer to - item 5 - in => [ Power Steering Gear Assembly Overview ] See: Power Steering Gear Assembly Overview.
Set the (VAG 1332) to 75 Nm to tighten the bolt - C -.
This specification applies only in conjunction with (T40037).
-
Use the (T40037) to tighten this bolt.