A8 Quattro Sedan V8-4.2L (BGK) (2006)
Stabilizer Bar: Service and Repair
Subframe, Engine Carrier and Stabilizer Bar Assembly Overview
Subframe, Engine Carrier and Stabilizer Bar Assembly Overview
1
Subframe
‹› Removing and installing, refer to => [ Subframe ] See: Subframe/Front Subframe/Service and Repair.
2
Self Locking Nut
‹› Always replace.
3
Guide Link
‹› Removing and installing, refer to => [ Guide Link ] See: Radius Arm/Service and Repair/Guide Link.
‹› Replace the hydraulic bushing if leaking. Refer to one of the following:
‹› => [ Guide Link Bushing, 65 mm ] See: Radius Arm/Service and Repair/Guide Link Bushing, 65 mm.
‹› => [ Guide Link Bushing, 75 mm ] See: Radius Arm/Service and Repair/Guide Link Bushing, 75 mm.
4
Bolt, 70 Nm + 180° additional turn
‹› Always replace.
‹› Raise the wheel bearing housing before tightening. Refer to => [ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See:
Wheel Bearing/Service and Repair/Procedures/Front Suspension.