A8 Quattro Sedan V8-4.2L (BGK) (2006)
Pinion Gear: Service and Repair
Drive Pinion Overview
Drive Pinion Overview
Replace both tapered roller bearings at the same time.
Install the new tapered roller bearing and do not oil it.
Place the rear final drive in the assembly stand => [ Place the Rear Final Drive in the Assembly Stand ] See: Drive Pinion
*
It is necessary to perform an adjustment if these parts are replaced. Refer to => [ Adjusting Overview ] See: Pinion and Ring Gear, Adjusting.
1
Nut
‹› Removing => [ Removing the Pinion Nut ] See: Drive Pinion
‹› Installing => [ Pinion Nut, Tightening and Friction Torque, Adjusting ] See: Drive Pinion
‹› Measuring the friction torque => [ Friction Torque, Measuring ] See: Drive Pinion
‹› Securing => [ Pinon Nut, Securing ] See: Drive Pinion
2
Driveshaft Flange
‹› Remove => [ Removing the Flange ] See: Drive Pinion
‹› Installing => [ Flange, Installing ] See: Drive Pinion
3
Seal