A8 Quattro Sedan V8-4.2L (BGK) (2006)
Assembly/Service and Repair/Overhaul/01AA,01EA,02XA,0A3A,01VA,09EA,09LA Transmission/Rear Final Drive Overview
‹› Removing and installing Audi A8, refer to => [ Rear Final Drive Overview ] See: Differential Assembly/Service and
Repair/Overhaul/01AA,01EA,02XA,0A3A,01VA,09EA,09LA Transmission/Rear Final Drive Overview
2
Gasket
‹› Replace
‹› Remove protective film.
‹› Remove grease from flange shaft and adhere seal.
3
Driveshaft
‹› For removing and installing on the Audi A4, the Audi Cabriolet and the Audi A6, refer to => [ Driveshaft ] See: Removal and Replacement
‹› Removing and installing Audi A8, refer to => [ Driveshaft ] See: Differential Assembly/Service and Repair/Removal and
Replacement/01AA,01EA,02XA,0A3A,01VA,09EA,09LA Transmission/Audi A8
4
Balancing Washer
‹› Not present on every vehicle
‹› Possibly located between a hex socket head bolt - 5 - and a backing plate - 6 - on the rear final drive
‹› If present, this balancing washer must no longer be installed after disconnecting driveshaft from rear final drive.
5
Hex Bolt
‹› Always replace
‹› 55 Nm
‹› Self-locking
‹› Always clean the threaded holes in the flange shafts. (for example, use a thread cutter)
‹› Use the counterhold tool Touareg V10 (T10172) and adapters (T10172/5) to loosen or tighten
6
Backing Plate
7
Intermediate Bearing
8
Hex Bolt
‹› 25 Nm
9
Drive