A8 Quattro Sedan V8-4.2L (BVJ) (2008)
Trim Panel: Service and Repair
Upper B-Pillar Trim
Trim
2 - Upper B-pillar trim
‹› Removing
-
Unclip lower B-pillar trim in area of the upper B-pillar trim.
-
Remove nuts - 6 - (Qty. 2).
-
Remove upper B-pillar trim - 2 - downward.
-
For complete removal: Remove outer anchoring point => [ Outside Floor Assembly Anchorage Point ] and guide belt webbing - 7 - out.
‹› Installing
CAUTION!
Always follow installation sequence for upper B-pillar trim
-
Complete removal: Install outer anchoring point => [ Outside Floor Assembly Anchorage Point ] and guide belt webbing - 7 - in.
-
Clip upper B-pillar trim - 2 - on brackets - 1 - (Qty. 2).
-
Make sure the retaining pins - 4 - engage in the mount - 5 - on the eat belt height adjuster.
-
Press on upper B-pillar trim - 2 -.
-
Screw in nuts - 6 - (Qty. 2).
CAUTION!
Ensure trim is held securely.
-
Make sure that door rubber is pulled cleanly over upper B-pillar trim.
-
Check function of belt height adjuster.
3 - Clips (Qty. 2)
4 - Retaining pin on upper B-pillar trim
5 - Mount on belt height adjuster
6 - Nuts (Qty. 2)
7 - Belt webbing