A8 Quattro Sedan V8-4.2L (BVJ) (2008)
-
Insert the vehicle-specific single wire end from the front into the pliers jaws as far as the stop and squeeze the pliers together completely.
-
Open the pliers again and remove the stripped wire end.
-
Twist bare strands one-half turn.
-
Repeat the procedure on the other end of the vehicle specific individual wire.
-
Adjust the sliding stop in the (VAS 1978/3) jaws to 6 to 7 mm for the wire to be stripped.
-
Insert the yellow repair wire end from the front into the pliers jaws as far as the stop and squeeze the pliers together completely.
-
Open pliers again and remove the stripped wire end.
-
Repeat this procedure on the other repair wire end.
-
For the repair of a 0.25 mm 2 wire, use a small yellow crimp connector from the (VAS 1978 B).
-
To press the crimp connector, use the (VAS 1978/1-2) with (VAS 1978/1-1) from the (VAS 1978 B).