A8 Quattro Sedan V8-4.2L (BVJ) (2008)
Brake Light Switch: Service and Repair
Brake Light Switch
‹› Brake Light Switch must be removed for adjustment.
‹› To ensure secure installation, switch may only be installed once.
Removing
-
If applicable, remove the lower air duct.
-
Separate the electrical connection.
-
Remove the brake light switch by rotating it 45° toward the left.
Installing
Installation is the reverse of removal, with special attention to the following:
-
Pull out the plunger of the brake light switch completely - arrow -.
-
Insert switch with tabs - 1 - and - 2 - in designated retainers in assembly opening.
‹› The brake pedal must not be actuated during installation.
‹› When installing the brake switch, the plunger adjusts itself automatically.
-
Guide switch through mounting hole, press against pedal and secure by turning 45° to right.