A8 Quattro Sedan V8-4.2L (BVJ) (2008)
-
Remove right engine support with engine mount.
‹› The B+ line can only be removed after disconnecting terminal 50 electrical connector.
-
Remove ground wire - 1 -.
-
Remove electrical wires - 3 - and - 4 -.
-
Remove bolts - 2 - and - 5 - and remove starter.
Installing
Install in reverse order of removal, observing the following:
‹› When installing, install cable ties at same location.
-
Install engine carrier and subframe.
-
Install engine support.
-
Install stabilizer bar.
-
Connect battery. Required actions, refer to => [ To connect, connect terminal clamp of ground (GND) wire by hand to battery negative terminal
and tighten nut. ] See: Tools and Equipment/Battery, Disconnecting and Connecting.
Tightening Specifications