A8 Sedan V8-3.7L (AEW) (1997)
Rear Door Window Glass: All Technical Service Bulletins
Sunshade, Replacing
-
Remove screw -1- holding drive disc -2-to motor, then remove drive disc -2-.
-
Remove 3 screws holding drive motor to assembly and remove motor.
-
Check drive shapes on electric motor and new sunshade drive plate.
If electric motor drive and new sunshade drive plate shapes match- sunshade reassembling.
If drive shape on motor does not match plate on sunshade, install correct plate from adapter kit Part No. 4D0 898 057 as follows:
CAUTION!
Part numbers are for reference only. Always check with your Parts Dept. for the latest parts in formation.
-
Remove two tie rods (with drive plate) from sunshade assembly (note orientation of tie rods).
-
Drill out rivets -arrows- holding tie rods to drive plate.
-
Install new bearings in tie rods at drive plate (incl. in kit).
-
Select drive plate from kit (match electric motor drive shape).
-
Install tie rods on new drive plate using pins and circlips (incl. in kit).
Note:
Foam pads -3- must be transferred to new sunshade.