A8 Sedan V8-3.7L (AEW) (1997)
9
-
Locking plate
10
-
Backing plate
11
-
Damper washer
Fig. 1 Removing and Installing Rear Window
-
Lightly pry locking plate - 1 - using small screwdriver and slide it out of groove on guide pin - 4 -.
-
Remove backing plate - 2 -.
-
Lightly pry door glass from guide pin and remove from vehicle downward.
NOTE: Guide pin will simultaneously push buffer pad out of door window guide.
-
Remove damper washer - 3 -.
-
When installing, align slot in door window so it is centered relative to guide pin - 4 -; pay attention to contact area on roof frame and at C-pillar.
NOTE: The buffer plug helps seal the window and minimize noise. It must be reinserted in the door window guide at the B-pillar after installing
the door window.
Fig. 2 Adjusting Rear Door Window Stop