A8 Sedan V8-3.7L (AEW) (1997)
Sunroof / Moonroof Panel: Adjustments
Sunroof Panel Height, Adjusting
Vehicles with aluminum sunroof panel
Adjust height at front and rear as shown to avoid wind noise.
-
Check height adjustment at center of front and rear edges of roof opening.
-
vorn = front
-
Front edge of roof panel should not be higher than the roof opening along any point.
-
The rear edge of the roof panel should not be lower than the rear edge of the roof opening along any point.
-
To adjust height, always close sunroof from the open position.
Vehicles with solar (e.g. glass) sunroof panel
NOTE:
-
If the car is equipped with a glass panel, the height of the panel must be measured from the top of the panel seal.
-
In this case, the weather seal of the panel should not be higher at the front or lower at the rear than the roof at any point.
-
-A- = front
-
To adjust front height, loosen screws -1- and -2-.
Tightening torque: 4.5 Nm (40 in. lb)
Rear height adjustment
-
To adjust rear height, loosen screws -2- and -3-.
Tightening torque: 4.5 Nm (40 in. lb)
-
Adjust height as shown in illustrations.