A8 Sedan V8-3.7L (AEW) (1997)
6 - ATF filter
7 - Screw
^
8 Nm (71 inch lbs.)
^
For mounting valve body
^
M6x 30, quantity: 1
^
M6 x 60, quantity: 16
8 - Valve body
9 - Screw
^
8 Nm (71 inch lbs.)
^
Note information for screw -7-
10 - Bracket for wiring harness
^
Secures wiring harness
^
Attached with screws for valve body
11 - Screw
^
6 Nm (53 inch lbs.)
12 - Transmission Vehicle Speed Sensor(VSS) -G38-
13 - Oil tube, inner
^
Usually replaced after removal
14 - O-ring
^
Always replace
^
Coat with Vaseline
15 - Spacer sleeve
^
Height: 8 MM
16 Speedometer - Vehicle Speed Sensor(VSS) -G22-
17 - O-ring Always replace
^
Coat with special grease
18 - Multifunction Transmission Range(TR) Switch -17125-
19 - Screw
^
8Nm (71 inch lbs.)
20 - O-ring
^
Always replace Coat with Vaseline
21 - Safety clip
^
For wiring harness connector
^
Engage holding tab when installing
22 - Wiring harness
^
Transmission fluid temperature sensor -G93- integrated into wiring harness
^
Disconnect from wiring harness bracket-10-
^
Installation position of wiring harness connector: flat part of backing collar points down, tabs on collar are horizontal
23 - Screw
^
6 Nm (53inch lbs.)
24 - Sensor for transmission RPM -G182-
25 - Spacer sleeve
^
Height: 20 MM
26 - Screw
^
6Nm (53 inch lbs.)
27 - Bracket for pressure regulator
28 - Solenoid valve -4N91-
^
With O-ring
^
Coat O-ring with thin layer of Vaseline to install
29 - Solenoid valve 3 N90-
^
Without O-ring
30 - Solenoid valve -2N89-
^
Without O-ring
31 - Screw
^
6 Nm (53 inch lbs.)
32 - Bracket for solenoid valves
33 - Solenoid valve 6 N93-
^
With O-ring
^
Coat O-ring with thin layer of Vaseline to install
34 - Solenoid valve -7N94-
^
With O-ring
^
Coat O-ring with thin layer of Vaseline to install
35 - Solenoid valve -5N92-
^
With O-ring
^
Coat O-ring with thin layer of Vaseline to install
36 - Solenoid valve 1 -N88-