A8 Sedan V8-3.7L (AEW) (1997)
Stabilizer Bushing: Service and Repair
Rear
Rear Stabilizer Bushing
Note: Always replace bushings on both sides of vehicle.
Removing
^
Remove Phillips-head screw -1-.
^
Remove clip -2- from recess -3- at subframe.
^
Remove bushing.
Pay special attention to the information when installing
^
Rubber bushing must make contact with collar -arrow- of anti-roll bar.
^
Insert clip -2- in recess -3- at subframe.
^
Do not tighten Phillips-head screw -1- until vehicle is standing on the ground.
Tightening torque: 30 Nm (22 ft. lbs.)