A8 Sedan V8-3.7L (AEW) (1997)
Rear Door Window Glass: Customer Interest
Sunshade, Reassembling
-
Install electric motor to assembly using 3 screws (incl. in kit).
Note:
Do not tighten screws at this time.
-
Using new screw 1 (incl. in kit) install new drive plate (with tie rods attached) onto motor.
Note:
Longer Phillips head screw is used for star shaped drive plate.
-
Establish an external 12v power supply then, extend sunshade completely.
-
Tighten 3 screws holding motor to bracket.
-
Operate unit and check that both arms retract evenly (pay particular attention to the first 100 mm of travel).
Note:
If sunshade chatters during operations lubricate track using a lightweight grease.
If necessary loosen 3 screws holding motor to bracket and adjust until both arms operate evenly (see examples below),
^
Lever arm on left side retracts sooner than right side (adjust motor to the right)
^
Lever arm on right side retracts sooner than left side (adjust motor to the left)
-
Adjust until both arms operate evenly.
-
Tighten all screws
Note:
Extend sunshade approx. 10 mm (to aid in reassembly into vehicle.
-
Remove external power supply.
-
Reinstall sunshade assembly to parcel shelf.
-
Reconnect electrical connectors for control unit and stop light.
-
Reinstall parcel shelf, seat belts, speakers and seats into vehicle in reverse order of removal.
-
Check sunshade for proper function.