A8L V8-4.2L (BFM) (2004)
-
Remove Torx bolt - arrow - T8 on wind deflector motor - 2 - from rear.
-
Positioning bow - 1 -.
-
Reach into cutout for interior light and remove Torx bolt - 2 - from wind deflector motor - 1 - from front.
-
Connector - 1 - disconnected
-
When looking toward front, rotate wind deflector motor downward approx. 90 degrees
-
Pull out motor toward rear.
Installation:
-
Guide in motor through cutout for light.
-
Insert control lever - 2 - into opening of front section of frame and pin - arrow - in both longitudinal holes of positioning bow.
-
Bring motor into bolting position.
-
Bolt motor with both Torx bolts T8.