A8L V8-4.2L (BFM) (2004)
Crankshaft: Service and Repair
Crankshaft Assembly Overview
‹› Secure the engine to the assembly stand using the engine and transmission holder (VAS 6095) when performing repair work. Refer to => [ Engine,
Securing on Engine Stand ] See: Service and Repair/Engine, Securing on Engine Stand.
1
Bolt, 22 Nm
‹› For the bearing cap.
‹› Always replace.
‹› Tightening sequence, refer to => [ Crankshaft Bearing Cap, Installing ].
2
Alignment Sleeve
‹› Install in the cylinder block.
3
Oil Pump Drive Sprocket
‹› Removing and installing, refer to => [ Oil Pump Drive Sprocket ] See: Engine Lubrication/Oil Pump/Service and Repair/Oil Pump Drive
Sprocket.
4
Crankshaft Bearing Cap
‹› Observe the identification. Refer to => [ Crankshaft Bearing Cap Identification ].
‹› Removing, refer to => [ Crankshaft Bearing Cap, Removing ].