A8L V8-4.2L (BFM) (2004)
‹› The notch on intake camshaft is slightly offset inward toward drive chain roller - 16 -.
‹› Do not mark the chain using a center punch or similar means!
Continuation
-
Secure the camshaft adjuster using the (3366).
‹› If the (3366) is fastened too tightly, the camshaft adjuster can be damaged.
-
Independent of the existing markings on the bearing caps, mark the sequence and installed position on all bearing caps, as shown in the illustration.
-
For marking, clean the bearing cap and use a waterproof felt tip pen.
-
Remove the bolts for the camshaft adjuster- 10 -.
-
Remove the bearing cap 1.
-
Remove the bearing caps 2, 4, 6, 8 and 9 and lay on a clean surface in the corresponding sequence.
-
Alternating in diagonal sequence, loosen the bearing caps 3, 5 and 7 for the intake and exhaust camshafts and remove.
-
Remove both camshafts with the camshaft adjuster.
Installing
-
Replace the bolts for the camshaft bearing caps and camshaft adjuster.
-
Replace the half round sealing plugs.
-
Remove the sealant residue from the cylinder head and bearing caps.
-
Replace the rubber/metal gasket and apply a thin bead of sealant on the hatched surface.