A8L V8-4.2L (BFM) (2004)
^
Remains on fuel tank when tank is removed
12 - Fuel tank
13 - Bush
14 - Bracket
^
For fuel tank
15 - 22 Nm
16 - Rubber buffer
17 - Washer
18 - 22 Nm
19 - 22 Nm
20 - Securing strap
^
with spacer, installing location; Refer to Fig 2
21 - Retaining clip
^
For heat shield
22 - Heat shield
23 - Retaining clip
^
For heat shield
Fig. 1 Position Ground (GND) connection
-
Fit Ground (GND) connection as shown in illustration.
-
Ensure that plug connector for Ground (GND) connection is properly seated on metal ring on fuel filler neck (arrow).
CAUTION: After installation, use an ohmmeter to check the electrical connection between the metal ring on the fuel filler neck and a bare metal part
on the body:
^
Specification: approximately 0 Ohm
Fig. 2 Installing location of spacers
-
Make sure that the spacers for the securing straps are properly fitted directly under seam on fuel tank (arrow).