A8L V8-4.2L (BFM) (2004)
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› The camera visual area on the inside of the window must not be covered with condensation or dirty. If it is, clean the visual window by hand using
a cleaning solution (D 009 401 04).
‹› If the directional stabilization assistance control module is replaced, the camera and the control module must be re-calibrated. Refer to => [ Lane
Assist Calibration ] See: Maintenance/Alignment/Service and Repair/Procedures/Lane Assist Calibration.