A8L V8-4.2L (BFM) (2004)
Front Steering Knuckle: Service and Repair
Wheel Bearing Housing, Removing and Installing
Wheel bearing housing, removing and installing
Special tools and equipment
^
V.A.G 1332 Torque wrench
^
V.A.G 1576 Torque wrench
Removing
During assembly, make sure that there are no indentations the boot of the air spring damper.
^
Place vehicle on lifting platform
^
Remove drive axle collar bolt
^
Disconnect connector -1- from speed sensor and remove wire from holder -arrow-.
^
Remove brake caliper and attach to body with wire.
^
Removing brake disc.
^
Separate the joint pins of the control arm from the tapered seat of the wheel bearing housing (nut remains loose on the joint pin)
^
Separate the joint pins of the guide link from the tapered seat of the wheel bearing housing (nut remains loose on the joint pin).