A8L V8-4.2L (BFM) (2004)
^
Remove ATF screw plug -A- and drain ATF.
^
Loosen 24 bolts on oil pan in diagonal sequence.
^
Remove oil pan.
Installing
Install in reverse sequence; note the following points:
^
Clean all 6 magnets in depressions in oil pan. Ensure that magnets are in full contact with oil pan.
^
Completely remove any residue of old seal and clean sealing surfaces before assembling.
^
Replace seals and gaskets.
^
Tighten bolts for oil pan diagonally in several stages.
Note:The screw plug with seal must be replaced.
^
Top up ATF.
Tightening torques