A8L V8-4.2L (BFM) (2004)
Output Shaft: Service and Repair
Right Side Flange Shaft, Removing and Installing
Right side flange shaft, removing and installing
Special tools, testers and auxiliary items
^
Drip tray V.A.G 1306
Removing
Note: Before raising the vehicle on a hoist (wheels off the ground), first activate the vehicle jack mode.
^
Remove heat shield for right side axle shaft.
^
Unbolt axle shaft from flange on transmission and tie up.
^
Place drip tray V.A.G 1306 below transmission.
^
Place a chisel or spacer piece -A- under flange shaft and remove flange shaft by turning bolt -B-.
Note: If flange shaft does not pull out easily, rotate shaft and screw bolt into hole on opposite side.