A8L V8-4.2L (BFM) (2004)
3. Apply paste on flange area of bearing unit (Figure 2, blacked out area).
NOTE:
Do not apply Optimol paste to the threaded holes.
4. Reassemble the wheel-bearing unit. See Repair Manual >> Suspension >> Wheels and Steering Group 40 >> Wheel bearing, replacing.
For vehicles produced from VIN 4E_4N 006891
Tip:
Do not replace front wheel bearings.
1. Remove both front wheel-bearing units (Figure 1, 6) from wheel bearing housings (Figure 1, 1). Do not separate wheel hub (Figure 1, 5) from
wheel bearing (Figure 1, 3).
WARNING: The collar screw and all 4 cap screws must be replaced when disassembling and reassembling the wheel-bearing unit.
2. Apply a layer of Optimol paste (part number G 052 109 A2) on periphery of mating surface of wheel-bearing unit as indicated by slash marks in
Figure 2.
3. Apply paste on flange area of bearing unit (Figure 2, blacked out area).
NOTE:
Do not apply Optimol paste to the threaded holes.
Warranty
When procedure applies to vehicles under warranty, use the following:
SAGA
All warranty claims submitted for payment must be in accordance with the Audi Warranty Policies and Procedures Manual. Claims are subject to review
or audit by Audi Warranty.