A8L V8-4.2L (BFM) (2004)
Lamp Cleaning Module: Service and Repair
Headlight Washer Jets, Removing and Installing
Headlight Washer Jets, Removing And Installing
Removing
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Move cover -1- of spray jet at bumper into "open" position.
-
Pull out spray jet -2- upward by hand as far as it will go.
-
Use small screwdriver to release clip -arrow- on side of jet.
-
Lift jet insert out of cylinder.
Installing
Install in reverse order of removal, noting the following:
-
Slide jet insert into cylinder until it engages.
-
Heed installation position.
-
Lugs -arrows- on jet insert must engage in recesses at cylinder