A8L Quattro Sedan V8-4.2L (AUX) (2001)
^
Pressing on go to Fig. 3
12 - Outer race of large tapered roller bearing
^
Driving out go to Fig. 12
^
Driving in go to Fig. 13
13 - Shim S2
^
Note thickness
14 - Threaded piece
15 - Differential bevel gears, large
^
Adjusting Figs. 8 and 9
16 - Differential bevel gears, small
^
Installing go to Fig. 7
17 - Axle for differential bevel gears
^
Drive in using mandrel
^
Drive in carefully so that thrust washers do not get damaged
^
Secure with clamping sleeve
18 - Shim
^
Determine thickness again go to Figs. 8 and 9
19 - Thrust washer
^
Check for cracks and breakage
Fig. 1 Pulling off inner race of large tapered roller bearing
^
Place thrust piece 40-105 on differential gear housing before installing pulling device.
Fig. 2 Pulling inner race of tapered roller bearing off of housing
A- Two-arm puller (standard commercial), e.g. Kukko 44/2