A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Rotate assembly carrier on to the rear side.
-
Slide rubber grommets - 7 - (Qty. 2) over guide tubes - 8 -.
-
Push rubber grommets - 7 - (Qty. 2) into holes - 6 -.
-
Vehicles with long wheel base: slide pipe clamps - 5 - (Qty. 2) over guide tubes - 8 - so that they point to each other, refer to illustration.
-
Vehicles with short wheel base: slide pipe clamps - 5 - (Qty. 2) over guide tubes - 8 - so that they point outward.
-
Pipe clamps - 5 - must lock with catches - 10 -.
-
Insert thread of pipe clamps - 5 - into assembly carrier - 9 -.
-
Loosely screw in nuts of pipe clamps - 5 - on the front side.
-
Install end caps - 3 - (Qty. 2).
-
Install hose clamps - 4 - (Qty. 2) so that they point outward, refer to illustration.
1
Shaft
2
Protective sleeves
3
End caps
4
Hose clamps
5
Pipe clamps