A8L Quattro Sedan W12-6.0L (BSB) (2005)
‹› Disconnect hoses leading to the power steering oil cooler at the bottom of the condenser, refer to => [ Condenser Refrigerant Lines
Disconnecting and Connecting ] See: Heating and Air Conditioning/Hose/Line HVAC/Service and Repair/Condenser Refrigerant Lines,
Connecting and Disconnecting.
‹› Disconnect hose for air guide.
‹› Pull off gasket for left and right front flap at juncture of fender at lock carrier - 1 -.
‹› Remove the bolts - 2 -;- 7 - - 9 - and - 10 -.
‹› The bolt - 7 - is installed behind the front wheel housing liner front part.
‹› Remove the nut from the banjo bolt at the top of the fender, refer to => [ Securing Lock Carrier/Fender ].
‹› Pull lock carrier off toward front.
‹› Installing:
‹› in reverse order
‹› The headlamps must be set.
‹› Adjusting:
‹› A second technician will be needed to hold the lock carrier - 1 -.
‹› Lock carrier - 1 - must be aligned between the fenders.
‹› When fenders and front bumper are replaced, they must adjusted in conjunction with lock carrier.
2 - Bolt
‹› 23 Nm
3 - Front Brace
‹› Installation position, refer to => [ Front Brace Assembly Overview ] See: Fender/Front Fender/Service and Repair/Front Brace Assembly
Overview
4 - Bolt
‹› 25 Nm
5 - Bolt
‹› 30 Nm
6 - Front Brace Bracket
7 - Bolt
‹› 23 Nm
‹› Installation position, refer to => [ Front Brace Assembly Overview ] See: Fender/Front Fender/Service and Repair/Front Brace Assembly
Overview.
8 - Bolt
‹› 10 Nm
9 - Nut
‹› 30 Nm
‹› Installed only on the Audi S8.