A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Place drip tray (V.A.G 1306) or drip tray (VAS 6208) under engine.
-
Disconnect coolant hose - arrow -.
-
Remove bolts in the sequence - 1 to 7 -.
-
Remove oil filter housing.
Installing
Installation is in reverse order of removal, note the following:
‹› Replace seals and O-rings.
‹› Secure all hose connections using hose clamps appropriate for the model type.
-
Tighten oil filter housing bolts in sequence - 1 to 7 -.
-
Install front oil pipe => [ Front Oil Pipe ] See: Oil Line/Service and Repair.
-
Align subframe according to the markings on the longitudinal members.
-
Tighten bolts for subframe only to specified torque. Do not tighten further (tighten bolts only after axle alignment).
1. 50 Nm
2. 150 Nm