A8L Quattro Sedan W12-6.0L (BSB) (2005)
‹› Ignore items - 1 to 3 -.
-
Disconnect electrical connection - 6 - at throttle valve control module (J338).
-
Disconnect vacuum hose - 1 -.
-
Pull off hoses - 4 - and - 5 - for the crankcase breather.
-
Remove bolts - 2 - and - 3 -.
-
Remove right intake manifold side-part.
‹› Minimal oil residue in the intake manifold side part is acceptable
Installing
Installation is in reverse order of removal, note the following:
‹› Replace O-rings.
‹› Replace gasket for intake manifold side part if damaged.
‹› During installation, protective heat boots must be re-installed at the same location.
‹› Secure all hose connections using hose clamps appropriate for the model type.
Tightening Specifications