A8L Quattro Sedan W12-6.0L (BSB) (2005)
‹› Removing and installing, refer to => [ Compressor Pulley, Version 2 ] See: Service and Repair
‹› Tightening specification 35 Nm
‹› A plastic washer may be glued on, depending on time period of production. Refer to => [ Compressor Pulley, Version 2 ] See: Service and
Repair.
3
Circlip
‹› Replace
‹› Install on proper side (level side to compressor)
‹› Removing and installing, refer to => [ Compressor Pulley, Version 2 ] See: Service and Repair
4
Spacer
‹› Dimensions: 17.5 x 10 x 3 mm
5
Rubber element
‹› 6x, install on proper side. Refer to => [ Compressor Pulley, Version 2 ] See: Service and Repair
‹› Decouples belt pulley from compressor driveshaft, damps vibrations and noise.
‹› for installation, lightly coat rubber elements, with tire mounting paste or a soap solution as a lubricant
6
Belt pulley
‹› Belt pulley is made of plastic and is sensitive to impact, therefore handle it with especial care
‹› Different versions,
‹› Removing and installing => [ Compressor Pulley, Version 2 ] See: Service and Repair
7
Compressor
‹› Different versions are installed, depending on engine version and country version of vehicle.
‹› Clean compressor flange before sliding on pulley.