A8L Quattro Sedan W12-6.0L (BSB) (2005)
Tail Lamp: Service and Repair
Outer Tail Lamps, Through 08.07
Outer Tail Lamps, through 08.07
=> [ Outer Tail Lamps ]
=> [ Tail Lamp LED Circuit Boards ]
=> [ Tail Lamp Control Module ]
Observe notes on contact corrosion. Refer to => [ Contact Corrosion ] See: Service Precautions.
Outer Tail Lamps
Removing
-
Switch off ignition and remove ignition key.
-
Turn light switch into "0" position.
-
Unclip plugs - arrows - from luggage compartment lining.
-
Remove nuts - 2 -.
-
Push rear lamp outwards and disengage from retaining pin at body.
-
Disconnect electrical harness connector at tail lamp.
Installing
Install in reverse order of removal, observing the following:
‹› Replace adjusting nuts if sealing washer is damaged.
-
Remove double-sided adhesive tape - arrow - at body cover panel and rear lamp.