A8L Quattro Sedan W12-6.0L (BSB) (2005)
‹› Do not start the engine or tow the vehicle if there is no ATF in the transmission.
‹› The oil drain plug and seal must be replaced.
-
Tighten the new drain plug - arrow A - to 12 Nm.
Fill the Transmission with ATF.
-
Remove ATF inspection plug - arrow B -.
-
Guide filler hook of (V.A.G 1924) from underneath into an opening in the cap - arrow -.
-
Add ATF using (V.A.G 1924) until ATF drips from the check hole.
-
Move the selector lever into P.
-
Start the engine, wait 20 seconds and then turn it off.
-
Add ATF using (V.A.G 1924) until ATF drips from the check hole.
-
Start the engine.
-
Continue to add ATF using the (V.A.G 1924) until ATF starts to come out again from the check hole.
-
Tighten the ATF inspection plug.
-
With engine idling depress the brake pedal and shift the selector lever through all the selector lever positions leaving the selector lever at least 10
seconds in each position.
-
Move the selector lever into N.
-
Increase the RPM to 2000 and hold it there for at least 60 seconds.
-
Move the selector lever into P.
-
Check the ATF level and correct if necessary. Refer to => [ ATF Level, Checking ] See: ATF Level, Checking.
‹› Follow the instructions and test requirements for checking the ATF level.