A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Tighten the banjo bolt - 2 -. Refer to - item 12 - in => [ Power Steering Pump Assembly Overview ] See: Steering and
Suspension/Steering/Service and Repair/Removal and Replacement/Power Steering Components.
-
Install the suction hose - 3 - with a new clamp - 4 - and tighten the clamp. Note the installed position. Refer to - item 15 - in => [ Power Steering
Pump Assembly Overview ] See: Steering and Suspension/Steering/Service and Repair/Removal and Replacement/Power Steering Components.
-
Top off the hydraulic fluid.
-
Clean any hydraulic fluid that leaked into the engine compartment.
-
Install the ribbed belt.
-
Check the power steering fluid level. Refer to => [ Power Steering Fluid Level Checking, Engine Codes BSM and BSB ] See: Steering and
Suspension/Steering/Testing and Inspection/Component Tests and General Diagnostics/Power Steering Fluid Level Checking, Engine Codes BSM
and BSB.
-
Bleed the steering system. Refer to => [ Steering System, Bleeding after Reconstructing ] See: Steering and Suspension/Steering/Power
Steering/Power Steering Bleeding/Service and Repair.
-
Check the steering system for leaks. Refer to => [ Steering System, Checking for Leaks ] See: Steering and Suspension/Steering/Testing and
Inspection/Component Tests and General Diagnostics/Steering System, Checking For Leaks.
-
Place the vehicle on its wheels. Refer to => [ Positioning Vehicle on the Hoist and on its Wheels ] See: Steering and
Suspension/Suspension/Service and Repair/Procedures/Positioning Vehicle on the Hoist and on its Wheels.
Suction Hose Installed Position
-
The marking - P - on the suction hose - 1 - must align with the formed seam on the pump - 2 - - arrows -.