A8L Quattro Sedan W12-6.0L (BSB) (2005)
/Page-2600003.png)
-
Check wires for short circuit to each other, to vehicle Ground (GND) and to B+. Specification: infinite ohms
-
Erase DTC memory of Engine Control Module => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing
and Procedures/Diagnostic Modes 01 - 09, Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code => [ Readiness Code, Generating ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
If no malfunction is detected in the wiring and if the voltage supply was OK:
-
Replace Throttle Position sensor.
-
Erase DTC memory of Engine Control Module => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Testing and Inspection/Scan Tool Testing
and Procedures/Diagnostic Modes 01 - 09, Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code => [ Readiness Code, Generating ] See: Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes.
