A8L Quattro Sedan W12-6.0L (BSB) (2005)
Cylinder bank 2
-
Connect test box to E ngine Control Module (ECM) 2 (J624) wiring harness on connecting test box for wiring test, refer to Repair Manual,
Cylinder bank 1 and 2
-
Check wires between test box and 4-pin connector to Engine Control Module for open circuit according to wiring diagram. Wiring resistance:
max. 1.5 ohms
Cylinder bank 1
Cylinder bank 2
Cylinder bank 1 and 2
-
Check wires for short circuit to B+ and Ground (GND). Specification: infinite ohms
-
Erase DTC memory of Engine Control Module => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09, Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code => [ Readiness Code, Generating ] See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes.