A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Start engine and run at idle speed. Specification: at least 7.0 V
If specification is obtained:
-
Switch ignition off.
-
Erase DTC memory of Engine Control Module => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09, Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code => [ Readiness Code, Generating ] See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes.
If specification is not obtained:
-
Connect multimeter to terminal 3 of connector to Engine Control Module + Ground (GND) for voltage measurement. Specification: at least 11.0 V
-
Switch ignition off.
If specification is not obtained:
-
Check voltage supply at 6-pin connector terminal 3 to Motronic Engine Control Module (ECM) Power Supply Relay 2 (J670) according to wiring
diagram:
-
Erase DTC memory of Engine Control Module => [ Diagnostic Mode 04 - Erase DTC Memory ] See: Computers and Control Systems/Testing
and Inspection/Scan Tool Testing and Procedures/Diagnostic Modes 01 - 09, Diagnostic mode 4: Reset/erase diagnostic data.
-
Generate readiness code => [ Readiness Code, Generating ] See: Computers and Control Systems/Testing and Inspection/Monitors, Trips, Drive
Cycles and Readiness Codes.
If specification is obtained: