A8L Quattro Sedan W12-6.0L (BSB) (2005)
/Page-2344002.png)
-
Disconnect electrical connections - 1 - at ignition coils - 2 -.
-
Remove ignition coils from spark plugs using Ignition Coil Puller (W8 & W12 Eng.) (T10166).
-
Using spark plug removal tool (3122 B), remove spark plugs.
-
Check compression using compression tester (V.A.G 1763).
‹› Using tester => operating instructions.
-
Have a second technician press accelerator pedal completely and at the same time operate starter long enough until pressure increase no longer
appears on tester.
-
Install spark plugs and ignition coils.
-
Install intake manifold side parts => [ Left Intake Manifold Side-Section ] See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and
Repair/Left Intake Manifold Side-Section and => [ Right Intake Manifold Side-Section ] See: Engine, Cooling and Exhaust/Engine/Intake
Manifold/Service and Repair/Right Intake Manifold Side-Section.
-
As a final step, check DTC memory of Engine Control Module (ECM) and erase it, since malfunctions were stored by removing the fuse and
disconnecting the electrical harness connectors.
