A8L Quattro Sedan W12-6.0L (BSB) (2005)
1
Camshaft Position (CMP) Sensor 1 (G40) on intake camshaft
4
Camshaft Position (CMP) Sensor 3 (G300) on exhaust camshaft
Cylinder bank 2
-
Disconnect corresponding 3-pin connector from Camshaft Position (CMP) sensor:
Camshaft Position (CMP) sensors 2 and 4
1
Camshaft Position (CMP) Sensor 4 (G301) on exhaust camshaft
4
Camshaft Position (CMP) Sensor 2 (G163) on intake camshaft
Cylinder bank 1 and 2
‹› Before disconnecting harness connectors, mark allocation to component.
‹› Cylinder bank 1 with cylinders 1 through 6 is located at right in direction of travel.
‹› Cylinder bank 2 with cylinders 7 through 12 is located at left in direction of travel.
Checking voltage supply
-
Connect multimeter to terminal 1 (B+) and 3 (Ground (GND)) of the respective connector for Camshaft Position (CMP) sensor for voltage
measurement.