A8L Quattro Sedan W12-6.0L (BSB) (2005)
Suspension Control Pressure Sensor/Switch: Service and Repair
Track Control Arm, Guide Link and Level Control System Sensor Assembly Overview
1
Subframe
‹› Assembly overview, refer to => [ Subframe, Engine Carrier and Stabilizer Bar Assembly Overview ] See: Stabilizer Bar/Service and
Repair/Front Suspension/Subframe, Engine Carrier and Stabilizer Bar Assembly Overview.
2
Guide Link
‹› Removing and installing, refer to => [ Guide Link ] See: Radius Arm/Service and Repair/Guide Link.
‹› Replace the hydraulic bushing if leaking, refer to => [ Guide Link Bushing, 75 mm ] See: Radius Arm/Service and Repair/Guide Link
Bushing, 75 mm.
3
Bolt, 70 Nm + 180° additional turn
‹› Always replace.
‹› Raise the wheel bearing housing before tightening. Refer to => [ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See:
Wheel Bearing/Service and Repair/Procedures.
4
Self Locking Nut, 120 Nm
‹› Always replace.
‹› If the guide link is not replaced, remove the locking compound from the ball joint threads first.
5
Self Locking Nut