A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Tighten the bolts/nuts on components with bonded rubber bushings by hand. Raise the wheel bearing housing to tighten the bolts/nuts. Refer to =>
[ Wheel Bearing Housing, Raising to Control Position to Tighten Bolts ] See: Rear Knuckle/Service and Repair/Procedures.
-
Install the coupling rod to the trailing arm.
-
Insert a new bolt - 1 - and install the brake line bracket - 2 - at the same time.
-
Tighten the new nut by hand.
-
Attach the coupling rod to the stabilizer bar using a new bolt - arrow -.
-
Tighten the bolt - arrow - connecting the coupling rod/stabilizer bar to specification. Refer to - item 5 - in => [ Stabilizer Bar, Track Control Arm,
Tie Rod, Coupling Rod, Connecting Link, Trailing Arm and Level Control System Sensor Assembly Overview ] See: Stabilizer Bar, Track
Control Arm, Tie Rod, Coupling Rod, Connecting Link, Trailing Arm and Level Control System Sensor Assembl.
-
Tighten the nut connecting the coupling rod/trailing arm/brake line bracket to specification. Refer to - item 25 - in => [ Stabilizer Bar, Track
Control Arm, Tie Rod, Coupling Rod, Connecting Link, Trailing Arm and Level Control System Sensor Assembly Overview ] See: Stabilizer Bar,
Track Control Arm, Tie Rod, Coupling Rod, Connecting Link, Trailing Arm and Level Control System Sensor Assembl.
-
Remove the (T10149) and the (VAG 1383A).
-
Install the wheel and tighten.
-
Place the vehicle on its wheels. Refer to => [ Positioning Vehicle on the Hoist and on its Wheels ] See: Service and Repair/Procedures/Positioning
Vehicle on the Hoist and on its Wheels.