A8L Quattro Sedan W12-6.0L (BSB) (2005)
-
Press the clamps onto the rubber bushing.
-
Engage the clamp - 2 - into both side of the opening - 3 - on the subframe.
-
Tighten the stabilizer bar clamp bolts - 1 - on both sides evenly by hand.
Left Side
-
Tighten the bolts - 1 - evenly, refer to - item 4 - in => [ Stabilizer Bar, Track Control Arm, Tie Rod, Coupling Rod, Connecting Link, Trailing
Arm and Level Control System Sensor Assembly Overview ] See: Stabilizer Bar, Track Control Arm, Tie Rod, Coupling Rod, Connecting Link,
Trailing Arm and Level Control System Sensor Assembl.
-
Tighten the stabilizer bar bolt - arrow - to the coupling rod. Refer to - item 5 - in => [ Stabilizer Bar, Track Control Arm, Tie Rod, Coupling Rod,
Connecting Link, Trailing Arm and Level Control System Sensor Assembly Overview ] See: Stabilizer Bar, Track Control Arm, Tie Rod,
Coupling Rod, Connecting Link, Trailing Arm and Level Control System Sensor Assembl.
To install the tie rod, proceed as follows:
-
Tilt the tie rod into the subframe.
-
Insert the eccentric bolt and the eccentric washer.
-
Rotate the eccentric washer on the marking on the subframe and tighten the nut - 2 -. Refer to - item 14 - in => [ Subframe Assembly Overview ]
See: Subframe/Rear Subframe/Service and Repair.