A8L Quattro Sedan W12-6.0L (BSB) (2005)
If the air spring damper will be replaced, note the information found here, refer to => [ Air Spring Damper, Filling ].
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› When installing, make sure the boot is not damaged and there are no pressure points.
-
Insert the air spring damper and tighten the bolts - 6 - (quantity: 3). Refer to - item 34 - in => [ Air Spring Damper, Wheel Bearing Housing and
Wheel Hub and Bearing Assembly Overview ] See: Service and Repair/Rear Suspension.
-
Tighten the bolt - 5 -. Refer to - item 39 - in => [ Air Spring Damper, Wheel Bearing Housing and Wheel Hub and Bearing Assembly Overview ]
See: Service and Repair/Rear Suspension.
-
Tighten the nut - 4 -. Refer to - item 33 - in => [ Air Spring Damper, Wheel Bearing Housing and Wheel Hub and Bearing Assembly Overview ]
See: Service and Repair/Rear Suspension.
-
Connect the connector - 3 -.
-
Tighten the connecting piece - 1 - to the residual pressure retaining valve - 2 -. Refer to - item 37 - in => [ Air Spring Damper, Wheel Bearing
Housing and Wheel Hub and Bearing Assembly Overview ] See: Service and Repair/Rear Suspension.
Right Air Spring Damper
-
Install the ventilation hose connection - 4 - to the filler neck.
Continuation for Both Sides