A8L Quattro Sedan W12-6.0L (BSB) (2005)
Suspension Control Module: Procedures
Level Control System Control Module -J197-, Removing and Installing
Level control system control module -J197-, removing and installing
Removing
-
If the control module is to be replaced, in the "Guided fault-finding" select the "Replace" function of the relevant control module.
Use vehicle diagnostic, testing and information system VAS 5051 for this purpose.
Note: The level control system control module -J197- is installed behind the glove box on the bulkhead.
-
Removing glove compartment.
-
Remove air duct in front of control unit.
-
Release the connector -1- from the control module in the direction of the arrow and detach.
-
Remove control unit -2-.
Installing
Installation is in reverse order. Note the following:
-
Perform the adaptation procedure for level control system control module -J197-.