A8L Quattro Sedan W12-6.0L (BSB) (2005)
Tire Pressure Monitor Antenna: Service and Repair
Rear Receiver Antenna
Rear Receiver Antenna
Special tools, testers and auxiliary items required
‹› Torque wrench (5-60 Nm) (VAG 1783)
Removing
The receiver antennas are located behind the wheel housing liners.
-
Place the vehicle on the hoist. Refer to => [ Positioning Vehicle on the Hoist and on its Wheels ] See: Suspension/Service and
Repair/Procedures/Positioning Vehicle on the Hoist and on its Wheels.
-
Switch the ignition off.
-
Remove the wheel housing liner.
-
Disconnect the electrical connector - 1 -.
-
Release the clip - 2 -.
-
Remove antenna - 3 -.
-
Remove the bracket from the rear receiver antenna.
-
Unclip the antenna.
-
Remove the nuts - 1 -.